Random Modeling Tip
To aid assembling parts with CA as well as to avoid unintentionally bonding a model to something, I assemble the parts on the surface of an old stainless steel ruler. The CA bonds to the stainless just enough to help hold parts in alignment while they set, but it's easy enough to gently pop them off the ruler with the tip of a sharp knife.
Kit BuildingRandom Articles
Hopper Weathering Clinic III
By Bill Mock
January 2010
OK, I gave the inside of these hoppers a wash of Engine Black below the coal line. They [ ... ]
InstructionalsRead more...I have always wanted to start a blog, but 'starting' it is usually the first stumbling block. This is true with a 2' by 5' canvas behind me for a [ ... ]
MyBlogRead more...
Hopper Weathering Clinic II
By Bill Mock
December 2009
So here's how those BN Hoppers turned out after the surface rust dried. Not bad. I'll [ ... ]
InstructionalsRead more...












